Parkside PISG 100 A1 handleiding

Niet gecategoriseerd

Parkside

61 pagina's

PDF beschikbaar

Handleiding

GB/IE/NI

 Welding

Choose between push and drag welding. The following section shows the impact of the direction of

movement on the properties of the weld seam:

Push welding Drag welding

Burn smaller larger

Weld seam width larger smaller

Weld bead ﬂ atter higher

Weld seam fault larger smaller

NOTE: You decide for yourself which type of welding is most suitable, once you have welded a

sample piece.

NOTE: Once it has worn down completely, the electrode must be replaced.

 Maintenance and cleaning

NOTE:

The welder must be regularly serviced and overhauled for proper function and for compliance

with the safety requirements. Improper and wrong operation may cause failures and damage to the

device.

 Before performing cleaning work on the welding tool, disconnect the power cable

from the power

outlet to ensure the tool is safely isolated from the power supply.

 Clean the exterior of the welder and its accessories regularly. Use compressed air, cotton waste or a

brush to remove dirt and dust.

NOTE: The following kinds of maintenance work must be performed only by suitably-qualiﬁ ed

personnel.

 The current regulator, earthing device and internal cables must be serviced regularly.

 Check the insulation resistance levels of the welder regularly. To do this use an appropriate

measuring device.

 In case of a defect or a necessary replacement of equipment parts, please contact the appropriate

qualiﬁ ed personnel.

385180_2107_Inverter_Schweissgeraet_PISG_100_A1_content_LB6_GB.indb 17385180_2107_Inverter_Schweissgeraet_PISG_100_A1_content_LB6_GB.indb 17 16.12.21 11:3016.12.21 11:30

Bekijk gratis de handleiding van Parkside PISG 100 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.