Parkside PHLGA 20-Li C2 handleiding
Handleiding
Je bekijkt pagina 11 van 77
11 GB/CY
Initial start-up
When used for the first time, some smoke may
escape. The smoke is caused by binders which
are removed from the insulating film of the heater
by the heat during first use. To ensure that the
smoke escapes quickly, the product should be
placed on the standing position with it’s battery
pack on it’s base. Be sure to ventilate the work-
ing environment during first use. If the smoke/
odour is too strong, move the initial start-up to
outside!
Operation
Removing/inserting the
rechargeable battery
To remove the battery
6
from the product,
press the release button
7
on the battery
and pull the battery
6
out.
To insert the battery
6
, push the battery
6
along the guide rail into the product.
You will hear it click into place.
Switching ON and OFF
Press and hold the release switch
4
.
Press and hold the ON/OFF switch
3
. You
can let go of the release switch
4
. The prod-
uct saves the level you were working in and
starts back up in the most recently used level.
- Press the Level 0 switch
13
for blowing
air to cool down.
- Press the Level I switch
11
for level I
hot air blowing. The product will reach an
air temperature up to 250 °C (by using
supplied restrictor
8
).
- Press the Level II switch
12
for level II
hot air blowing. The product will reach an
air temperature of up to 550 °C (by using
supplied restrictor
8
).
To switch off, release the ON/OFF switch
3
.
The LEDs
14
above the step switch display
the level at which the product is currently
operating.
Keep the product in the standing posi-
tion with it’s battery pack on it’s base
for allowing the product to cool down after use.
Use of adapter nozzles
Before exchanging adapter nozzles, the
adapter nozzle
8
/
9
/
10
and blow-off
pipe
1
must be sufficiently cooled down to
avoid burns.
Various uses are possible. Always com-
ply with the safety instructions and al-
ways handle the product with care and caution.
Restrictor
Place the restrictor
8
on the blow-off
pipe
1
. Use the restrictor
8
to obtain
selective heat.
When using the restrictor
8
, pay par-
ticular attention to the heat development
at the cutting point. If in doubt, do not stay in
the same place for too long in order to avoid
overheating the workpiece.
Surface nozzle
Place the surface nozzle
10
on the blow-off
pipe
1
.
Use the surface nozzle
10
to obtain heat
over a large surface.
When using the surface nozzle
10
, pay
particular attention to the heat develop-
ment in adjacent locations of the cutting point.
So that in cases of doubt, no adjacent compo-
nent is overheated.
Reflector nozzle
Place the reflector nozzle
9
on the blow-
off pipe
1
. Use the reflector nozzle to sol-
der and tin pipes, as well as to shrink shrink
tubing.
Bekijk gratis de handleiding van Parkside PHLGA 20-Li C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PHLGA 20-Li C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7184 MB |
