Parkside PHLG 2000 F5 handleiding
Handleiding
Je bekijkt pagina 18 van 114
GB MT
18
Use as a oor-mounted
appliance
You can use the device as a oor-mounted
appliance. For this purpose, place the de-
vice on the two bases (9).
Ensure stability and safety and a heat-
resistant surface.
The position as a oor-mounted
appliance is also ideally suited to
allowing the device to cool down
after use.
Use of adapter nozzles
Before exchanging adapter noz-
zles, the adapter nozzle (5/6/7/8)
and blow-off pipe (4) must be suf-
ciently cooled down to avoid burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.
Restrictor
Place the restrictor (8) on the blow-off pipe
(4).
Use the restrictor (8) to obtain selective
heat.
When using the restrictor (8), pay
particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.
Surface nozzle
Place the surface nozzle (6) on the blow-off
pipe (4).
Use the surface nozzle (6) to obtain heat
over a large surface.
When using the surface nozzle (6),
pay particular attention to the heat
development in adjacent locations
of the cutting point. So that in cases
of doubt, no adjacent component is
overheated.
Spatula nozzle
Place the spatula nozzle (7) on the blow-off
pipe (4).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers must be removed with a spatula.
The spatula nozzle (7) itself is not suitable
for removing paint.
Grill lighter nozzle
Place the grill lighter nozzle (5) on the
blow-off pipe (4).
Change the device with the step switch
( 3) to level "II". Place the grill lighter
nozzle (5) below the charcoal. Make sure
that the openings of the grill lighter nozzle
(5) are not covered by charcoal as this cre-
ates heat accumulation in the unit, which is
a potential re hazard In just a few minutes
the charcoal is ignited.
Never use other methods for ignit-
ing charcoal at the same time while
using the grill lighter nozzle (5).
Use the grill lighter nozzle (5) only
for the few minutes necessary to
ignite the charcoal.
Never use the grill lighter nozzle
(5) for any other application.
Bekijk gratis de handleiding van Parkside PHLG 2000 F5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PHLG 2000 F5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14328 MB |
