Parkside PDNB 6.3 B2 handleiding
Handleiding
Je bekijkt pagina 17 van 90
■ 14
│
GB
│
IE
PDNB 6.3 B2
■ Hold the machine correctly: Be ready to counter-
act any normal or sudden movements – keep
both hands ready.
■ Ensure that your body is balanced and that you
have a secure standing position.
■ Release the start/stop control in case of a
disruption to the power supply.
■ Use only the lubricants recommended by the
manufacturer
.
■ Avoid direct contact with the machine tool
during and after use as it will have heated up.
■ Always use sharp tools.
■ Avoid inappropriate postures as they can make
it impossible to respond to normal or unexpected
movements of the nibbler or shears.
■ Unexpected movement of the machine or break-
age of the blades can cause injury.
■ Warning: there is a risk of explosion or fire due
to the material being worked
.
Hazards caused by repetitive
movements
■ When using a nibbler or shears to perform
work-related activities, operators may experi-
ence uncomfortable sensations in their hands
and arms, as well as in the neck and shoulders
or other parts of the body.
■ When using nibblers or shears, the operator
should adopt a comfortable posture whilst
ensuring a secure hold and avoiding awkward
postures or positions in which it is difficult to
maintain balance. The operator should change
positions during the course of long-lasting tasks.
This can be helpful in the prevention of discom-
fort and fatigue.
■ If the operator notices symptoms such as persis-
tent or recurring illness, discomfort, throbbing,
pain, tingling, burning or stiffness, these indica-
tions should not be ignored. The operator must
inform his/her employer and seek the advice of
a suitably qualified medical practitioner
.
Hazards caused by accessories
■ Disconnect the nibbler or shears from the power
supply before replacing the machine tool or
accessories.
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of the nibbler or the shears; do not use any other
types or sizes of accessories or consumable
materials.
■ Cutting edges can heat up during use; they must
not be touched.
■ Do not use accessories or machine tools that
have cracks or deformations.
Hazards in the workplace
■ Slipping, tripping and falling are the main causes
of injuries in the workplace. Look out for surfaces
which could have become slippery through use
of the machine and for any tripping hazards
caused by air or hydraulic hoses.
■ Proceed with caution in unknown surroundings.
There may be hidden hazards due to power or
other supply lines.
■ The nibbler or shears are not intended for use in
explosive atmospheres and are not insulated
against contact with electrical power sources.
■ Do not operate the machine in the vicinity of
electric mains, gas pipelines, etc. which could
pose a hazard if damaged by the machine.
Bekijk gratis de handleiding van Parkside PDNB 6.3 B2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PDNB 6.3 B2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8582 MB |
