Parkside PALP 20-Li C3 handleiding
Handleiding
Je bekijkt pagina 11 van 33
PAK 20-Li C3
GB
│
IE
│
NI
│
7 ■
Before use:
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the charger before you
remove the battery pack from or connect it
to the charger.
NOTE
► The battery is partially charged. Ideally,
charge the battery completely before use.
This guarantees full battery performance.
Li-ion batteries can be charged at any time
without adversely affecting their service life.
Interruption of the charging process will not
damage the battery.
► Never charge the battery pack when
the ambient temperature is below 10°C or
above 40°C. If a lithium-ion battery is to be
stored for an extended period, the charge lev-
el should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Insert the battery pack into the high-speed
charger .
♦ Insert the mains plug into the mains socket. The
control LED lights up red to indicate that the
appliance is charging.
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready.
♦ Push the battery pack into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the battery pack into the handle until it
clicks into place.
Removing the battery pack:
♦ Press the release button and remove the
battery pack .
Checking the battery charge level:
♦ Press the battery charge level button to
check the charge level of the battery. The
status/remaining charge will be shown on the
battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operation
This appliance is not designed for continuous oper-
ation. The appliance may be used for a maximum
of 10 minutes of continuous operation. If the appli-
ance overheats, remove the battery pack . Allow
the appliance to cool down completely and then
try using it again.
Display
♦ Press the ON/OFF switch on the display
or press the ON/OFF switch to switch on
the display indicator .
♦ The last set pressure is displayed for 2 seconds.
♦ After two seconds, the current pressure of the
connected item is shown.
NOTE
► If the compressed air hose is not connected
to a suitable item, the display indicator
shows "0".
♦ If the display indicator is switched on, you
can switch between "bar" and "psi" by pressing
the ON/OFF button .
Bekijk gratis de handleiding van Parkside PALP 20-Li C3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PALP 20-Li C3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3558 MB |
