Parkside PAL 5.200 A1 handleiding
Handleiding
Je bekijkt pagina 8 van 29
8 GB/IE/NI
protective gloves at all times if such an event
occurs.
This product has a built-in rechargeable battery
which cannot be replaced by the user. The
removal or replacement of the rechargeable
battery may only be carried out by the manu-
facturer or his customer service or by a similarly
qualified person in order to avoid hazards. When
disposing of the product, it should be noted that
this product contains a rechargeable battery.
Before use
Charging the product
Note: Remove all packaging materials from the
product.
Note: In order to use the product without a USB
cable
6
, you need to recharge the rechargeable
battery before use. The charging process takes about
7hours. The rechargeable battery is firmly integrated
into the base of the product.
Note: This product may only be charged by using
the USB cable
6
provided with the specified input
voltage and current (see “Technical data”).
Connect the USB cable
6
with the charging
device.
Connect the USB (type C) connector on the
USB cable
6
to the USB (type C) input socket
7
on the product (see Fig. C).
Note: During charging, the charging indicator
8
lights up red. When charging is complete, the charging
indicator
8
lights up green. When the charging
indicator
8
is green, pull the USB cable
6
from
the product to prevent the battery from discharging.
Use
You can use the product in the following
ways:
- Use the product by holding the grip
3
at both
side of the strip light
1
.
- You can secure the product by using either one
or two hook
4
which is located at the base in
both sides. If using two hooks, hold the joint
5
and tilt up the grip
3
so it is perpendicular to
the strip light
1
. Then take out the hooks
4
and hang it on desired place (see Fig. B).
- You can use the product by securing it to a
flat, ferromagnetic surface using the magnetic
base
9
.
CAUTION! If you want to attach the product
to a surface in horizontal position, ensure the
magnet at both side were attached to the ferro-
magnetic surface (see Fig. E). Otherwise the
strip light
1
may fall down due to its weight.
You can adjust the lighting angle by rotating
the strip light
1
with your hand.
- You can attach the product on the provided tri-
pod
10
and make the product stand on desired
location (see Fig. D).
CAUTION! Make sure the grip
3
with ON /
OFF switch
2
is attached to the tripod
10
. Do
not tilt the strip light
1
more than 90 °, other-
wise the product may overturn.
CAUTION! Please note the position of your
hands whilst turning the grip
3
to prevent
pinching your fingers (see Fig. F).
Using the product
Fully charge the product as described in the
section “Charging the product“.
Press the ON / OFF switch
2
repeatedly to
switch the product into different modes.
Press 1x: Light up at one side
Press 2x: Light up at both side
Press 3x: Switch off the light
Maintenance and cleaning
The product requires no maintenance. The LEDs
cannot be replaced.
Switch off the product and disconnect from the
USB cable
6
before cleaning.
Never immerse the product in water or other
liquids.
Bekijk gratis de handleiding van Parkside PAL 5.200 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PAL 5.200 A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2507 MB |
