Parkside PAAL 6000 C2 handleiding
Handleiding
Je bekijkt pagina 11 van 25
11GB/IE/NI/CY
Before use
Charging the product
NOTES:
Remove all packaging materials from the
product.
You can charge the product by means of
the supplied power adaptor to a normal
household socket, or by means of the
supplied car adaptor to a 12 V car cigarette
lighter socket.
The fuse of the car charger adaptor [] can
be exchanged.
The technical data of the fuse must comply
with information given in the section
“Technical data”. The fuse may only be
replaced by a qualified electrician.
CAUTION! Do not connect the product to your
car‘s 12 V connection if the car battery is already
old and worn. Doing so could mean that the car
engine will no longer start.
NOTES:
In order to use the product without a
USB cable [], you need to recharge the
rechargeable battery before use. The
charging process takes about 3.5 hours. The
rechargeable battery is firmly integrated into
the base of the product.
Fully charge the rechargeable battery prior
to first use.
Charge the battery if it becomes empty
(only 1 LED of the charging indicator [6] is
flashing).
Open the protective cap [8].
Connect the USB cable [] with the
USB connector of the power adaptor [] or
the car charger adaptor [].
Connect the USB plug (type C) of the
USB cable [] to the USB input socket
(type C) [9] on the product.
Plug the power adaptor [] into a socket,
or plug the car charger adaptor [] into the
12 V socket in your vehicle.
NOTES:
The battery charging status is shown by the
charging indicator [6]:
Charging indicator [6]
status
Battery
charging
status
1 LED flashes 0‒25 %
1 LED lights up, 1 LED flashes 25‒50 %
2 LEDs light up, 1 LED flashes
50‒75 %
3 LEDs light up, 1 LED flashes
75‒100 %
4 LEDs light up 100 %
The charging time is approximately 3.5 hours
when the battery was drained.
NOTE: The product has an overcharging
protection system. Nevertheless, you should
disconnect the product from the mains once the
charging process is complete.
Disconnect the USB cable [] from the
product to prevent the batteries discharging
themselves.
Close the protective cap [8] before you start
to use the product again. Otherwise water
could enter to the product when it is used
outdoors.
Checking the battery capacity
When product is not charged: Press the battery
status button
[7]
to check the battery capacity.
The green charging indicator
[6]
shows the
capacity* of the battery inside the product.
1 LED lights up = 25 %*
2 LEDs light up = 50 %*
3 LEDs light up = 75 %*
4 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement.
Bekijk gratis de handleiding van Parkside PAAL 6000 C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PAAL 6000 C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2461 MB |
