Palmer Wipper handleiding
Handleiding
Je bekijkt pagina 13 van 50
13
EN
USER MANUAL
CONNECTIONS AND OPERATING ELEMENTS
1. INPUT A
Audio input with 6.3mm jack socket.
A. Connect an instrument using a
shielded instrument cable.
B. Connect the speaker output of a
guitar amplier using a speaker cable
(tip: Press PAD switch no. 5).
WARNING: Ampliers must not be operated in bridge mode on the DI box.
WARNING: If an amplier is operated on the DI box, the ground connection between
input and output must be disconnected (switch no. 6 in the non-pressed LIFT position).
WARNING: The amplier output of a connected amplier must not exceed 120 W at 8
ohms!
ATTENTION: When using a tube amplier: There is no load resistance in the DI box circuit!
In order to avoid damage to the amplier, a suitable guitar speaker or a suitable load resistor
must be connected to the THRU jack socket using a speaker cable before switching on the
amplier, and switch no. 3 must be in the unpressed LINK OUT position!
2. THRU/INPUT B
THRU: The input signal (INPUT A no. 1) is output unchanged via the 6.3 mm jack socket (switch no. 3 in non-pressed
position).
INPUT B: In addition to INPUT A, the 6.3 mm jack socket can be used as a second line input (e.g. keyboard L + R);
the signals from INPUT A and INPUT B are mono summed and output at the line output OUTPUT (no. 4) (switch no. 3
in pressed position).
3. SWITCH THRU/INPUT B
Switch not pressed (THRU): The input signal (INPUT no. 1) is output unchanged via the 6.3 mm THRU/INPUT B jack
socket.
Switch pressed (INPUT B): In addition to INPUT A (no. 1), the 6.3 mm THRU/INPUT B jack socket can be used as a
second line input.
DI box
passive
wipper
Bekijk gratis de handleiding van Palmer Wipper, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Palmer |
| Model | Wipper |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6599 MB |
