Owon OEL15 handleiding
Handleiding
Je bekijkt pagina 18 van 42
13
will increment the value to the right. Once it reaches the highest digit,
pressing it again will return to the lowest digit, and this will cycle
continuously.
3. Press On/Off key to output the setting voltage.
Mode two:
1. Press CV , at the same time, the user interface will switch into CV mode.
2. Press Enter key to edit voltage setting, turn the knob to directly adjust to
the set value. During the process of inputting a value, pressing the knob
will increment the value to the right. Once it reaches the highest digit,
pressing it again will return to the lowest digit, and this will cycle
continuously.
3. Press On/Off key to output the setting voltage.
In constant voltage mode, the user can also set the following parameters.
Operation steps:
1. Press F1 to enter parameter setting interface
2. Set the maximum working current
3. Set the voltage range
4. Set the rising/falling slope of the voltage
a) Fast b) Normal c) Slow
5. OCP, OVP, OPP setting
4.3.3 Constant Resistance Mode (CR)
When the user selects the SHIFT+ CV function key, the load enters constant
resistance mode (CR). In constant resistance operation mode, the electronic
load will behave as a constant resistor. The current will change linearly with
the input voltage. The relationship between voltage and current is shown in
the figure below.
Bekijk gratis de handleiding van Owon OEL15, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Owon |
| Model | OEL15 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6637 MB |
