Handleiding
Je bekijkt pagina 20 van 65
PHE 86
|
20
regulations of each country. Installation must comply with local regulations. In the absence of these
regulations, it must be carried out in accordance with the standard for storage and use of Liquefied
Petroleum Gases. A cracked, rusted, or damaged cylinder can be dangerous and should be checked by the
manufacturer or supplier. Never use a cylinder with a damaged valve.
LEAK TEST
The stove's gas connections have been pre-tested by the manufacturer prior to shipment. A safety check
must be performed during installation at the place of use to prevent loosening of parts due to shipping.
Make a soapy solution of one part water and one part soap. The soapy solution can be applied with a spray
bottle, a brush, or a rag. Soap bubbles will appear in the event of a leak. The stove must be tested with a full
cylinder. Ensure the control is in the off position. Turn on the gas supply to the regulator. In the event of a
leak, turn off the gas supply to the regulator. Tighten the connections with the appropriate clamps. Turn the
gas supply back on to check again. Repeat until the leak disappears. Do not smoke during the leak test.
USE OF THE STOVE
1. START-UP
1. Open the gas supply to the cylinder regulator.
2. Press and turn the control knob to the PILOT position (90º counterclockwise).
3. Push the control knob all the way in and hold for 60 seconds. Press the ignition button while holding it
down until you hear a steady click. Repeat until the pilot light ignites. Note: If you have just changed the
cylinder, hold the control knob in the PILOT position for at least one minute to bleed air from the gas lines.
The control knob can be released after the pilot light is lit.
If the pilot light does not light or goes out, repeat step 3.
4. After lighting the pilot light, turn the control knob to the maximum position and hold for 5 minutes or
more before turning the control knob to the desired temperature position.
2. TURN OFF THE STOVE
1. Turn the control knob to the PILOT position.
2. Press and turn the control knob to the off position.
Off: Off.
3. CLOSE THE GAS PASSAGE OF THE CYLINDER REGULATOR.
PARTS OF THE STOVE:
- PANEL:
Piezoelectric (Igniter) and Pilot (Ignition)
Lo: Minimum temperature (low flame)
Hi: Maximum temperature (high flame)
Off: Off
Bekijk gratis de handleiding van Orbegozo PHE 86, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Orbegozo |
| Model | PHE 86 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 8718 MB |
