Opticis VGDF-200 handleiding
Handleiding
Je bekijkt pagina 3 van 6
Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug and fasten the 5V power adapters to the +5V DC jack on the rear side of
converter. Ensure that the Power LED is ON (Blue).
Step 3
Please, check if the maximum resolution of the display is WUXGA
(1920x1200). Otherwise, follow the instructions for Self-EDID Programming
Procedure on page 1-5.
Step 4
Connect the VGA source to VGA IN port over VGA cable. If the VGA source
is active, status LED (Blue) will be turned on.
Step 5
Connect the OPTICAL OUT to 1-fibe DVI receiver, DVFX-100-R over multi-
mode SC-SC optical fiber.
Step 6
Plug DVFX-100-RX to DVI input port of display.
Step 7
If you need on-site monitoring, connect VGA OUT on the front side to VGA
input port of local monitor over VGA cable.
1-3 Installation
Note1: The maximum extension length by multi-mode fiber is 500 meters.
Note2: It is recommended NOT to use any intermediate cable or adapter in
between to avoid undesirable performance degradation.
Figure 1 – Connection Diagram of VGDF-200
1-4 Installation
VGA Source
Local
VGA Display
One (1) Optical Fiber
DVFX-100
Rx
Remote
DVI Display
Up to WUXGA
VGDF-200
Bekijk gratis de handleiding van Opticis VGDF-200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Opticis |
| Model | VGDF-200 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 794 MB |
