Omnitronic XO-300 handleiding
Handleiding
Je bekijkt pagina 16 van 20
5
55
5 Setup
Please ensure that only qualified persons install and operate the crossover. Improper cabling or setup could
damage your speaker systems.
Rack installation
This unit is built for 19" racks (483 mm) but can also be used as a tabletop unit. In order to ensure sufficient
cooling of the unit, air must always be able to flow freely through all air vents. For rack installation, 1 unit is
required. You can fix the unit with four M6 screws.
Cable connections
Disconnect the crossover from the mains and switch off the audio units to be connected before making or
changing the connections. For highest sound quality, only use high-grade, preferably short cables for all
connections.
1) Make the audio connections via XLR connectors. The jacks are designed for balanced signals.
However, it is also possible to connect sources with unbalanced signals. Balanced cables guarantee a
better protection against interference in case of long cable runs.
2) Connect the outputs of the signal source (equalizer, mixing console, etc.) to the inputs of the crossover.
Make sure the source is switched off. The crossover has an input impedance of 50 kΩ. This makes the
audio inputs suitable for use with any low-impedance source.
3) Connect the amplifiers to drive your speaker systems to the appropriate outputs of the crossover. Make
sure the amplifiers are switched off.
4) Connect the crossover to a mains outlet with the mains cable. Before plugging the unit in, always make
sure that the power supply matches the product specification voltage.
5) Finally make sure all components are properly connected. Ensure that the outputs of the crossover are
connected to the appropriate inputs of the amplifiers that drive the speaker systems.
Selecting the crossover frequencies
Always start the system setup by muting all outputs. Activate the HF outputs first. In case of wrong cabling,
high frequency (HF) audio signals will come out of bass speakers that cannot be harmed this way. Vice
versa, the low frequency (LF) audio signals would destroy your HF speakers. Use the literature supplied with
your speaker systems to properly set up the crossover frequencies to the manufacturer’s specifications. The
XO-300 is applicable for 3-way stereo systems. The crossover frequencies are continuously adjustable
between 80 and 920 Hz (LOW-MID), and 800 Hz and 9.2 kHz (MID-HIGH).
Powering up
To protect your audio equipment, specifically your speakers, follow this power-up sequence: Set all output
volume controls of any equipment to minimum. Switch on the signal source first, then the crossover. Always
switch on amplifiers last. Then set the signal source to its nominal operating level. Slowly turn up the volume
controls of your amplifier(s) until you can hear signal at a comfortable level. Make adjustments using tools
such as a measurement microphone, real-time analyzer, sound generator and familiar music material. For
switching off, follow the inverse sequence: always switch off amplifiers first, then the crossover and then the
signal source.
Bekijk gratis de handleiding van Omnitronic XO-300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omnitronic |
| Model | XO-300 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3389 MB |
