Omnitronic MSE-8+ handleiding
Handleiding
Je bekijkt pagina 17 van 24
17
•
EN
No. Element Function
1 Audio player with built-in
Bluetooth receiver and 5
operating buttons
[MODE/ ]: Short actuation = switches between USB, SD and Bluetooth
operation / long actuation = player on/off
[/VOL-] / [/VOL+]: Short actuation = title or folder selection / long
actuation = volume adjustment
[ /TWS]: Short actuation = selects repeat functions
/
long actuation =
pairing second speaker system (TWS function)
[►II/ ]: Short actuation = play/pause / long actuation = enters folder
selection mode
2 Memory card slot For inserting an SD(HC) card.
3 USB port For connecting a USB storage device.
4 Infrared sensor for the
remote control
When actuating a button, always direct the remote control towards the
sensor. There must be no obstacles between remote control and the
sensor.
5
AUX input Unbalanced stereo RCA input. Use a standard stereo RCA cable to
connect a line-level device (e.g. CD player) to this input.
6 Level control This control determines the level of the AUX input and the audio player.
Therefore, do not apply a signal via the AUX input when operating the
audio player. Otherwise, both audio sources will be played back
simultaneously.
7 Microphone input Connect the microphone to this input.
8 Level control To mix the microphone signal to the master signal.
9 Effect control
Adjusts the intensity of the internal echo effect for the microphone input.
10
Tone controls
2-band EQ for tuning the tone of the master signal.
11
MAIN LEVEL control Adjusts the overall volume.
12
Battery indicators
This LED chain indicates the charge status in battery mode. When the
capacity of the batteries is sufficient, the upper indicator lights up green.
If the lower red LED is lit, the battery should be charged.
13 Charge
indicator
This indicator lights up red during charging. When the battery is fully
charged, the indicator lights up green.
14 Power indicator Lights when the speaker system is powered on.
15 PEAK indicator
This indicator lights when the internal power amplifier section is
overloaded. Reduce the volume until the LED does not light anymore, or
only at signal peaks.
16 Light mode Selects the light mode for the integrated RGB LEDs.
Mode 1: 5-color change
Mode 2: 3-color change
Mode 3: sound-controlled color change 1
Mode 4: sound-controlled color change 2
Mode 5: mode 1-4 alternating
Next actuation: LEDs off
17 Power switch Switches the speaker system on and off.
18
Power input
Used to plug in the supplied power cord.
19
Fuse holder
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is
specified on the rear panel.
Bekijk gratis de handleiding van Omnitronic MSE-8+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omnitronic |
| Model | MSE-8+ |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 4504 MB |
