Omnitronic DXO-48E handleiding
Handleiding
Je bekijkt pagina 19 van 24
19
•
EN
5
Operation
If allowed by the access rights of the current access level and the currently loaded preset, all parameters for
the input and output channels can be changed directly at the unit without a computer. Modifications of
parameters affect the components connected immediately. To keep the adjustments permanently, they must
be saved as a preset ( section 5.3).
5.1 Input setup
Use the buttons CH UP and CH DOWN to select the input channel to be adjusted. Make the first settings
with the output turned low or muted. You can select the desired menu item with the buttons NEXT and
PREV. The respective parameters can be adjusted by turning or pressing the rotary encoder. Press ESC to
abort the setting procedure.
Note
• As a basic setting the input channels will be linked. Thus the input gain can be collectively adjusted for
every two inputs. This setting can be changed via menu item Channel Link.
5.1.1 Gain
Adjust the gain by turning the rotary encoder. The gain is adjusted in steps of 0.25 dB. Smaller steps (0.01
dB) can be set via the control software.
5.1.2 Input selection
Select the source by turning the encoder. Note: This function is only available when the Channel Link is not
active.
5.1.3 Channel link
By linking 2 channels, the settings are guaranteed to be identical for both channels, except for mixer and
mute. Turn the encoder to set the Channel Link on or off.
5.2 Output setup
Use the buttons CH UP and CH DOWN to select the output channel to be adjusted. Make the first settings
with the output turned low or muted. You can select the desired menu item with the buttons NEXT and
PREV. The respective parameters can be adjusted by turning or pressing the rotary encoder. Press ESC to
abort the setting procedure.
Note
• As a basic setting the output channels will be linked. Thus the following parameter modifications are
collectively adjusted for every two outputs (except for mixer and mute). This setting can be changed via
menu item Channel Link.
5.2.1 Gain
Adjust the gain by turning the rotary encoder. The gain is adjusted in steps of 0.25 dB. Smaller steps (0.01
dB) can be set via the control software.
Bekijk gratis de handleiding van Omnitronic DXO-48E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omnitronic |
| Model | DXO-48E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4942 MB |
