Omnitronic DXO-48E handleiding
Handleiding
Je bekijkt pagina 17 van 24
17
•
EN
4
Setup
4.1 Signal connections
When setting up the unit, make connections as follows:
– Always make input connections prior to applying power.
– Connect the outputs from the signal sources (e.g. preamplifier, mixer) to the XLR inputs.
– Connect the XLR outputs to the inputs of the PA amplifiers.
– Always make sure that your power amplifiers are the last item turned on and the first turned off.
– Once all of the connections have been made, and the unit is powered up, you can navigate through the
input signal path from the front panel. The display provides you with a clear and concise overview of each
aspect of the signal path.
4.2 Installation
This unit is built for 19" racks (483 mm) but can also be used as a tabletop unit. In order to ensure sufficient
cooling of the unit, air must always be able to flow freely through all air vents. For rack installation, 1 unit is
required. You can fix the unit with four M6 screws.
4.3 Switching on
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not supply power before all components of the system are set up and connected properly. Make
sure your power amplifiers are switched on last in order to avoid transients, which could damage your
speakers or annoy your audience. When you plug in the power adapter, the unit is powered on and is in
standby mode.
After switching on, the unit requires a short initialization process and is then ready for operation. The display
will show the product name and the name of the current preset.
Notes
• Use only the supplied power unit otherwise the unit will be damaged. The power cable can be secured to
the unit via the strain relief. Always disconnect the mains connector when you wish to change connections,
move the unit to a different place or if it is not used for a longer period.
4.4 System check
After connecting all cables, you should mute all outputs first or turn the gain/level setting on your amplifiers to
minimum. Activate the HF outputs first. In case of wrong cabling, High Frequency (HF) audio signals will
come out of bass speakers that cannot be harmed this way. Vice versa, the Low Frequency (LF) audio
signals would destroy your HF speakers. It is advisable to install a large capacitor in series with HF drivers
(47 to 100 uF). That way, drivers are somewhat protected against accidental instrumentation errors.
4.5 Remote monitoring and control
For the quickest and easiest results we recommend to install and use the control software DXO Control for
PC and Mac. It provides a complete and comprehensive tool to make your loudspeaker configuration
settings, and to manage your presets.
Connect the unit’s USB port to your computer via the supplied USB connection cable. If you have problems
with the USB connection, please refer to the guide for details on how to install the proper driver.
Bekijk gratis de handleiding van Omnitronic DXO-48E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Omnitronic |
| Model | DXO-48E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4942 MB |
