OmniMount Motion52 handleiding
Handleiding
Je bekijkt pagina 10 van 52
P10
WOOD INSTALL - STEP 3
Before lifting mount into position ensure that all pilot holes are drilled and
Toggler Anchors (W-D) necessary are installed. An assistant may be needed to
hold mount in position while installing screws. Install using the #3 Size Power
Drill Bit (W-C) with the Wall Screws (W-I) into Wood Stud Locations (x4).
EN
x4
W-I
W-C
Wood Stud
W-D
W-B
W-H
x3
W-I
W-B
Install the 3 additional Wall Screws (W-I) into the Toggler Anchor holes. The #3
Center Hole Must use a Washer (W-H). These 3 screws must be HAND
TIGHTEN ONLY with (W-B). Failure to do this will result of stripping the
Toggler Anchors.
EN
Bekijk gratis de handleiding van OmniMount Motion52, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | OmniMount |
| Model | Motion52 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15109 MB |
