Olympia A 130 handleiding

Handleiding

1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768697071727374757677787980818283848586878889909192/ 92

Afdrukken

Je bekijkt pagina 12 van 92

12

Laminating

Warning! Danger due to unexpected start-up! Make sure that the appliance is switched o󰀨

before connecting it to the mains.

1 Connect the power plug to a properly installed socket.

2 Switch the device on (ON) using the switch.

3 The indicator light Power is glowing red. The device is not yet ready for operation. The appliance

heats up.

Caution! Risk of burns due to hot appliance surface! Do not touch the surface of the

appliance during or immediately after operation.

Note: Wait until the appliance is fully heated up. Do not insert the laminating lm beforehand, as this

will prevent it from fusing properly.

4 Place the document to be laminated in the laminating lm. Make sure that there is a gap of ap-

prox. 3 - 5 mm to the edge of the lm on all sides.

Attention! Material damage possible! Only use laminating lms that are suitable for hot

lamination.

5 After 3 to 5 minutes, the LED display Ready lights up green and the device is ready for operation.

Attention! Material damage possible! Never insert the lamination foil into the feed area at

an angle.

Attention! Material damage possible! Always insert the closed end of the laminating lm

into the feed area of the laminator rst.

Note: Make sure that the laminating lm can be dispensed from the back of the device.

6 Guide the laminating lm with the closed side straight into the feed area until the laminating lm is

caught by the transport rollers.

7 The laminating lm is automatically pulled through the device.

Caution! Risk of burns due to hot appliance surface! Do not touch the surface of the

appliance during or immediately after operation.

Caution! Risk of burns from hot laminating lm! The laminating lm is very hot immediately

after lamination. When removing the laminating lm, only touch the cooled end.

8 Remove the laminating lm at the cooled end.

Tip: To atten the laminated document, place a book or similar heavy, at object on top of it.

9 Switch the device o󰀨 using the switch (OFF).

Note: Allow the laminating lm to cool before further use.

1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768697071727374757677787980818283848586878889909192/ 92

Bekijk gratis de handleiding van Olympia A 130, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd