Olimpia Splendid Sitali SF150 S1 handleiding

Niet gecategoriseerd

Olimpia Splendid

36 pagina's

PDF beschikbaar

Handleiding

SITALI SF 150 S1 is a single alternate flow decentralized (single point) residential heat recovery unit, also called «push&pull» unit, designed

to ensure adequate ventilation in enclosed environments without energy losses.

It is recommended that two units are installed in a pair: when one unit is pulling, the other is pushing.

The pair of units can be installed in the same room or in different rooms (i.e. living-room and bedroom). The unit is suitable for installation

on an outside wall.

Readthismanualcarefullybeforeusingtheproductandkeepitinasafeplaceforreference.

This product was constructed up to standard and in compliance with regulations relating to electrical equipment and must be installed by

technically qualified personnel.

The manufacturer assumes no responsibility for damage to persons or property resulting from failure to observe the regulations contained

in this booklet.

PRECAUTIONS FOR INSTALLATION, USE AND MAINTENANCE

•Thedeviceshouldnotbeusedforapplicationsotherthanthosespeciﬁedinthismanual.

•Afterremovingtheproductfromitspackaging,verifyitscondition.In case of doubt, contactaqualiﬁedtechnician.Donotleave

packaging within the reach of small children or people with disabilities.

•Donottouchtheappliancewithwetordamphands/feet.

•Thisappliancecanbeusedbychildrenagedfrom8yearsandaboveandpersonswithreducedphysical,sensoryormentalcapabilities

orlackofexperienceandknowledgeiftheyhavebeengivensupervisionorinstructionconcerninguseoftheapplianceinasafeway

and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by

children without supervision.

•Donotusetheproductinthepresenceofinammablevapours,suchasalcohol,insecticides,gasoline,etc.

•If any abnormalities in operation are detected, disconnect the device from the mains supply and contact a qualiﬁed technician

immediately. Use original spare parts only for repairs.

•Theelectricalsystemtowhichthedeviceisconnectedmustcomplywithregulations.

•Beforeconnectingtheproducttothepowersupplyorthepoweroutlet,ensurethat:

- the data plate (voltage and frequency) correspond to those of the electrical mains

 -theelectricalpowersupply/socketisadequateformaximumdevicepower.Ifnot,contactaqualiﬁedtechnician.

•Thedeviceshouldnotbeusedasanactivatorforwaterheaters,stoves,etc.,norshoulditdischargeintohotair/fumeventducts

derivingfromanytypeofcombustionunit.Itmustexpelairoutsideviaitsownspecialduct.

•Operatingtemperature:-20°Cupto+50°C.

•Thedeviceisdesignedtoextractcleanaironly,i.e.withoutgrease,soot,chemicalorcorrosiveagents,orammableorexplosive

mixtures.

•Donotleavethedeviceexposedtoatmosphericagents(rain,sun,snow,etc.).

•Donotimmersethedeviceoritspartsinwaterorotherliquids.

•Turnoffthemainswitchwheneveramalfunctionisdetectedorwhencleaning.

• Forinstallationanomnipolarswitchshouldbeincorporatedintheﬁxedwiring,inaccordancewiththewiringregulations,toprovideafull

disconnection under overvoltage category III conditions (contact opening distance equal to or greater than 3mm).

• Ifthesupplycordisdamaged,itmustbereplacedbythemanufacturer,itsserviceagentorsimilarlyqualiﬁedpersonsinordertoavoida

hazard.

•Donotobstructthefanorexhaustgrilletoensureoptimumairpassage.

•Ensureadequateairreturn/dischargeinto/fromtheroomincompliancewithexistingregulationsinordertoensureproperdevice

operation.

•Iftheenvironmentinwhichtheproductisinstalledalsohousesafuel-operatingdevice(waterheater,methanestoveetc.,thatisnota

“sealed chamber” type), it is essential to ensure adequate air intake, to ensure good combustion and proper equipment operation.

•InstalltheproductsothattheimpellerisnotaccessiblefromtheairoutletsideasveriﬁedbycontactwiththeTestFinger(testprobe“B”

ofthenormEN61032)incompliancewiththecurrentsafetyregulations.

INTRODUCTION

The unit should operate continuously, and only stopped for maintenance or service.

Whenheatexchangeisnotuseful(forexampleinmid-seasonswhenindoorandoutdoortemperaturesaresimilar),orwhenheat

exchangeisnotrecommended(forexamplewiththeoption“summerfreecooling”),itisrecommendedtosettheunitin“extract-only”

or“intake-only”modeandNOTtoswitchitoff.

Installation, use and maintenance manual SITALI SF 150 S1

•Designfrontcover(A)removableforcleaningwithouttheuseoftools.

•Innerventilationunit(B)andwallsupportbase(D)madeofhighquality,impactandUV-resistantABS,colourRAL9010.

•Integrated multi-colour led (C ) to obtain a visual feedback of the unit status.

•Smart humidity control.

•Integral temperature sensor for the automatic management of the inversion time (comfort mode).

•Automaticanti-frostprotectiontopreventfrostbuildingupontheheatexchanger.

•Wallsupportbase(D)providedwithamagnet“coupling/uncoupling”systemwhichallowstheventilationunittoberemovedfromits

base during maintenance.

•Back-uptouchbutton(E)atthesideoftheventilationunit.

•Unique design winglet-type impeller, providing enhanced aerodynamic properties, low noise and increased efficiency.

•HighefficientreversibleECmotorwithintegralthermalprotection,mountedonsealedforlifehighqualityballbearings.Designedfor

continuous reversible running.

•Telescopic pipe (F) adaptable to the wall thickness.

•Antimortar cap designed to be used also as template during the installation of the wall support base.

• Regenerativeheatexchangerwithceramiccore(G)withhighthermalefficiency,equippedwithwashableanti-dustfilters(H).

TECHNICAL SPECIFICATIONS

Bekijk gratis de handleiding van Olimpia Splendid Sitali SF150 S1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.