Olimpia Splendid Bi2 SLR SMART S1 handleiding

Niet gecategoriseerd

Olimpia Splendid

164 pagina's

PDF beschikbaar

Handleiding

EN - 43

ENGLISH

Bi2 SL/SLR-SMART S1

2.5 - VERTICAL FLOOR OR WALL INSTALLATION

 Whenmountingontheoorwithsupportfeet,refertotheindividualinstructionsleaetssuppliedandthe

relative manual for the mounting of the feet.

N.B. Do not damage the cardboard packaging, the templates needed for correct machine installation

are printed on the back and underside of it.

 Usethetemplatesonthepackaging(cutalongthelinesindicated),andtracethepositionofthetwoxing

bracketsonthewall(g.7).Useasuitabledrilltomaketheholeswithandinsertthetogglebolts(2for

eachbracket)(g.8ref.A);xthetwobrackets(g.8ref.B).Donotover-tightenthescrewssothatthe

bracketscanbeadjustedwithaspiritlevel(g.9).

 Fullytightenthefourscrewstoblockthetwobrackets.

 Checkthestabilitybymanuallymovingthebracketstotherightandtotheleft,upanddown.

 Mounttheunit,checkingthatittscorrectlyontothebracketsandcheckingthatitisstable(g.10).

2.6 - HORIZONTAL OR CEILING INSTALLATION (only for SL, SL SMART)

 Usingthetemplate,traceontheceilingthepositionofthetwoxingbracketsandthetworearscrews.

Usingasuitabledrill,maketheholesandinsertthetogglebolts(2foreachbracket)(g.11ref.A);xthe

twobrackets(g.11ref.B).Donotover-tightenthescrews.Positionthemachineonthetwobrackets,

keepingitinpositionandthenxthetwoscrewsintothereartogglebolts(g.11ref.C),oneoneachside.

 Makesurethatthereissu󰀩cientinclinationoftheunittowardsthedrainagepipetofacilitatethewater

drainage(g.11ref.D).

 Fullytightenall6xingscrews.

 ForinstallationoftheSLversions,horizontalcondensationcollectionbasinaccessorykitsareavailable.

2.7 - HYDRAULIC CONNECTIONS

2.7.1 - Pipeline diameter

The minimum internal diameter that must be respected for the pipelines of the hydraulic connections varies

according to the model:

SLR/SL 200 ø12 mm

SLR/SL 400 ø14 mm

SLR/SL 600 ø16 mm

SLR/SL 800 ø18 mm

SLR/SL 1000 ø20 mm

For the position of the pipeline and the wall xings, refer to the designs

shown in the following sections, based on the specic conguration.

Bekijk gratis de handleiding van Olimpia Splendid Bi2 SLR SMART S1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.