Olimpia Splendid Bi2 SLR AIR handleiding
Handleiding
Je bekijkt pagina 59 van 256
Bi2 Air TR
ENGLISH
EN - 15
2.12.a - Assembly and connections for models with console and recess
Once the connection operations and possible conguration are complete, close the electric panel by means
of the previously removed screws.
Reposition the front panel taking care to connect the connector of the display.
Secure the front panel by means of the screws, then power the machine.
- When the unit is congured for remote control, the remote controller is disabled.
- It is not possible to control the ap from remote control.
- In this mode, the air probe installed on board the fan coil is ignored.
2.13 - CONNECTION WITH SIOS CONTROL
- Connect the cables coming from the “A B” connection of SIOS CONTROL
with the respective wires on the mammoth connected to the panel lid, taking
care to respect the polarity, connecting the farthest unit with the 120 Ohm
resistor supplied with the appliance.
- Enable Autonomous conguration (paragraph “2.14”, conguration parameter
“CF”).
- Set the protocol type ASCII if SIOS CONTROL envisages B0863 or RTU if
SIOS CONTROL does not envisage B0863 (paragraph “2.14”, conguration
parameter “bU”).
- Set the address, each appliance must have an address different from all the
other units connected to the same BUS (paragraph “2.14”, conguration pa-
rameter “Ad”).
- As regards mounting of the connections, proceed by following the indications
described in the previous paragraphs.
2.14 - BOARD SOFTWARE CONFIGURATION
Work as follows:
a. Connect power supply, then ensure that the latter is set to any mode except for stand-by.
b. On the control panel, simultaneously press the key “ ” (T2) and “ ” (T1) for at least 5 seconds,
until an acoustic signal is emitted.
c. The display shows the reference to the parameter
d. Scroll using the key “ ” or “ ” (T1) until you select the desired parameter
e. Press the key “ ” or “ ” (T1) to scroll the list of parameters: CF -> bU -> Ad -> Fa -> Po -> co ->
CF -> …
f. Press key “ ” (T2) to access the value
g. Release and press key “ ” (T2) for more than 3 seconds to change the value (Display blinking)
h. Press key “ ” or “ ” (T1) to scroll the possible values of the parameters
i. Press key “ ” (T3) to conrm the value
j. Press key “ ” (T3) to exit the conguration or wait 20 seconds.
Quit and give power voltage to the system to start the unit under the new cong-
uration.
Bekijk gratis de handleiding van Olimpia Splendid Bi2 SLR AIR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Olimpia Splendid |
| Model | Bi2 SLR AIR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31446 MB |
