Handleiding
Je bekijkt pagina 22 van 38
Page
22
of
38
If the power cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
The appliance should not be placed immediately
below a socket.
WARNINGS ： In order to avoid
overheating, do not cover the heater.
Do not use this heater with a programmer, timer,
separate remote control system or any other
device that turns on the heater automatically
because there is a risk of fire if the device is
covered or placed incorrectly. Use only a remote
control device connected by the pilot cable.
The device must be powered by a Residual
Current Device (RCD) with a rated operating
differential current of not more than 30 mA.
Warning: if this appliance is installed in a
bathroom, it must be installed at least 60 cm
from a bath or shower (volume 2), in accordance
with the requirements of the French electrical
installation standard NFC 15 -100.
The device must be connected to a circuit
independent electric protected by a bipolar
circuit breaker according to the standard
electrical installation NF C 15-100.
WARNING: The heater must not be used if the
glass panels are damaged.
With respect to the details of how to install the
appliance onto the wall, refer to the
"INSTALLATION" section.
Bekijk gratis de handleiding van Oceanic OCEAISHGN2000W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Oceanic |
| Model | OCEAISHGN2000W |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 5269 MB |
