Handleiding
Je bekijkt pagina 25 van 43
Do not use this heater with a programmer, timer, separate remote control
system or any other device that turns on the heater automatically because
there is a risk of fire if the device is covered or placed incorrectly. Use only a
remote control device connected by the pilot cable.
The device must be powered by a Residual Current Device (RCD) with a rated
operating differential current of not more than 30 mA.
The device must be connected to a circuit independent electric protected by a
bipolar circuit breaker according to the standard electrical installation NF C 15-
100.
The heater must be installed so that switches and other control devices can
not be touched by a person in the bath or shower.
A means of disconnection from the power supply having a contact opening
distance of all poles must be included in the fixed wiring in accordance with the
installation requirements.
For your safety, the device is equipped with a thermal circuit breaker. In the
event of overheating, the power supply will be cut off.
With respect to the details of how to install the appliance onto the wall, refer to
the "INSTALLATION" section.
Regarding the detailed information on the connection of the electric cable,
refer to the section "ELECTRICAL CONNECTION".
INSTALLATION
RECOMMENDATIONS IMPORTANT READ BEFORE INSTALLATION
- Do not install the unit directly below a socket.
- Do not use the appliance outdoors.
WARNING: In order to avoid a hazard for very young children, this appliance
should be installed so that the lowest heated rail is at least 600 mm above the
floor.
Bekijk gratis de handleiding van Oceanic OCEAISH500W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Oceanic |
| Model | OCEAISH500W |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 6395 MB |
