Handleiding
Je bekijkt pagina 46 van 52
EN-18
VI. CLEANING AND MAINTENANCE
ICING
The humidity brought by the products and by the ambient air leads over time to
the formation of frost and ice in the appliance. A thin layer of frost or ice has no
influence on the operation of the freezer, but the thicker the layer becomes, the
higher the energy consumption. A thin layer of ice can be removed with a freezer
ice scraper.
Never use an electrical device or pointed object that could damage the inside of
the device.
When the frost or ice layer reaches a thickness of 4 to 5 mm, the freezer must
be defrosted. Defrosting is recommended when the freezer is near or completely
empty.
Proceed as follows:
1.
Unplug the unit.
2.
Take out the frozen products. Keep them in a cool or well-wrapped place to
minimize defrosting as much as possible.
3.
Leave the lid open.
4.
Place a container of hot (non-boiling) water in the freezer, close the lid and
wait about 30 minutes, then remove the frost with a plastic scraper. Never
use hair dryers, electric heaters or other similar electrical appliances for
defrosting.
5.
Drain all defrost water either with a cloth or a water collection tray through
the defrost hole (see instructions below). Clean and dry it with a soft cloth.
6.
Wait about five minutes after turning the machine back on before
putting frozen products back in.
Bekijk gratis de handleiding van Oceanic OCEACCF99W2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Oceanic |
| Model | OCEACCF99W2 |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 3840 MB |
