Obsidian Netron RDM10 handleiding
Handleiding
Je bekijkt pagina 21 van 45
21
MENU: SYSTEM
This menu contains all the settings to configure and manage the
device.
SUB MENU
OPTIONS / VALUES
Description
Device
Name
12 Character Label
(i.e. NETRON RDM10)
Set a device name
Device ID
0 – 999
Set an optional device ID
Display
Display Timeout
Disable
Display stays on indefinitely
10s, 30s, 1m, 5m,
10m
Display goes dark after this time
Screen
Brightness
1-10
Adjust the brightness of the internal display
LED Brightness
0-10
Adjust the brightness of the front LEDs. Set to 0 to disable
them.
Home Screen
Device Info
The display shows port and connectivity information
Cue Browser
The display shows a list of stored cues which can easily be
browsed and started by the encoder wheel
Art
-
Net
Offset
Universe 1: 0-0
Universe 1: 0-1
Lock Device
PIN: 000 (000)
Lock
Disable
The device does not require a pin
Timeout
The device asks for a pin after the display times out
Manual
Lock: 000
(000)
Lock /
Unlock
Lock the device immediately
Startup
Cue
Run a specific Cue at startup
Wait for Data
No DMX is sent until valid data is received for the ports. The
last incoming values continue to be sent on the ports until the
time is expired. Once timeout has completed the device will
perform one of the below actions
Send 0
Signal Loss
Hold Last Look
Forever, 0s, 10s,
30s, 1m, 5m, 10m,
60m
The last incoming values continue to be sent on the ports until
the time is expired. Once timeout has completed the device
will perform one of the below actions.
Fade to 0
0-60s (30s)
Crossfade to DMX 0. Set to 0s for instant out.
Cue
1-99
Start Cue X
Disable DMX
DMX traffic is turned off on all ports
Backup
Config
Save Config
Config Saved
Save current configuration including all cue data
Load Config
Config Loaded
Reload configuration. Backups can be exported and imported
from the web interface
RDM
Processing
All Disable
Disables RDM processing on the device
All Enable
Enables all RDM processing on the device
Factory
Reset
Pin: 000 (011)
Confirm
Device will be reset
to factory defaults.
Yes/No
Reset the device to factory default. It will reload NETRON
Preset 1. All cues are deleted, and all settings are set to
default.
Bekijk gratis de handleiding van Obsidian Netron RDM10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Obsidian |
| Model | Netron RDM10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10752 MB |
