Nubert nuLine RS-54 handleiding

Handleiding

12345678/ 8

Afdrukken

Je bekijkt pagina 3 van 8

3 3

Connections

Please make sure that your amplier/receiver is switched off

before connecting your speakers. For how to connect the speak-

ers to the amplier/receiver, please refer to the equipment‘s user

manual.

Terminal

You will nd the terminal for the speaker cable on the rear of the

speaker (when used in reective mode). The terminal has two bind-

ing posts, one with a red marking for plus and one with a black

marking for minus. Always make sure that plus on the loudspeaker

is connected to plus on the amplier and minus on the loudspeaker

to minus on the amplier. Reversing polarity will not harm your equip-

ment in any way, but the sound will be diffuse and bass-response

and imaging will be very poor. Most loudspeaker cables are marked

to make it easy to discern between plus and minus.

If you want to connect the speaker cable directly without any con-

nectors, remove 8 – 15mm of insulation from the end of the cable

and twist it so that no individual copper-strands stick out (caution:

danger of short-circuit). Loosen the binding post and insert the cable

from below. Tighten the binding post rmly!

Speaker Cables

Thin speaker cables are not a good way to transport the electrical

signal between amplier and speaker.

As such, the supplied speaker cables are to be considered an interim

solution, in case you didn’t order speaker cables with your speakers

and do not have quality cables available.

For the RS-54, we recommend using our nuCable LS 2,5 Studioline

2 x 2,5 mm

2

speaker cable for cable lenghts under 10 m. For longer

cable runs, we recommend the 2 x 4 mm2 nuCable LS 4 Studioline.

Mode Switch

Between the binding posts, you will nd a two-position switch. With

this switch, you optimize the sound of the speaker to either the

direct-radiating compact speaker- or the Dolby Atmos Enabled up-

ring role.

With the switch In the Direkt (direct) position, the RS-54 is a

normal, direct-radiating compact 2-way loudspeaker. Use this

setting if you want to use the RS-54 as your main- or surround-

loudspeakers. (more on page 4 and 5)

Setting the switch to Reektierend (reecting) is recommended

when using the speaker as a ceiling-reecting speaker for immersi-

ve audio formats. This setting changes the frequency response and

dispersion characteristics of the speaker to fulll all Dolby Labo-

ratories requirements for Dolby Atmos enabled up-ring speakers

with Dolby Speaker Technology. The RS-54 is fully tested and cer-

tied by Dolby Laboratories

▲ Direkt (direct)

▼ Reektierend (reecting)

Direct / Reecting mode-switch

EN 09/2020 · nuLine RS-54

12345678/ 8

Bekijk gratis de handleiding van Nubert nuLine RS-54, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Speaker