Nord Lead 2 handleiding
Handleiding
Je bekijkt pagina 21 van 114
Editing Programs Page 21
4. Editing Programs
Changing An Existing Program
Actually, how to change a programmed sound can be described in one sentence: “twist the knobs and
press the buttons”. It is as simple as that!
▼ For information about editing Percussion Kits, refer to page 30.
▼ Don’t be afraid to edit and overwrite the RAM Programs in the internal memory (Program 01 - 40). If later
you want to restore any of the original RAM factory programs, they are backed up as ROM Performances
as described on page 108.
Changing One Sound In A Layer
If you have layered sounds you can still edit one of the sounds from the front panel. Proceed as follows:
1. Press the Program Slot button that you want to edit.
Its LED will flash to indicate it is the active slot.
2. Use the front panel to change the sound.
Getting Back To The Programmed Sound
If you have edited a Program and want to get back to the programmed original, proceed as follows:
1. Select another Program for that slot.
2. Select the first Program again.
It will now have reverted back to the way it was when you selected it last.
Using Manual Mode
If you want to use the front panel to make up a sound from scratch, hold down Shift and press the Manual
(Performance) button. This leaves you with exactly the sound that the knobs and buttons on the panel
indicate (just as if the Nord Lead 2 was an old non-programmable instrument).
In Manual mode, the instrument only plays one Program, layering is not possible.
SPLIT POINT
MANUAL
PERF. MODE
KBD SPLIT
The Performance/Manual button.
Bekijk gratis de handleiding van Nord Lead 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Lead 2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11965 MB |
