Handleiding
Je bekijkt pagina 9 van 24
9
NILES AUDIO – 1-800-BUY-HIFI – 1-760-710-0992
one-speaker stereo Mode Vs. tWo-speaker stereo Mode
As can be seen in the coverage examples, the one-speaker stereo mode has
the advantage of covering a larger area than the two-speaker stereo mode. The
difference in coverage area between the one-speaker stereo mode and the two-
speaker stereo mode is signicant.
The trade off between the two congurations is volume. The two-speaker stereo
congurations will be able to play louder in their area than the one-speaker
stereo conguration.
Choosing the speaker Cable
In order to choose the proper speaker cable, please follow these steps:
• Unless you are using an impedance matching system, use care when
connecting RS PRO series loudspeakers to your amplier/receiver. An SI
model wired in single speaker stereo mode will present a 4 ohm load to the
amplier. All other models and an SI model wired for two-speaker stereo
mode will present an 8 ohm load . Verify the requirements of your amplier/
receiver prior to making any connections or running any wires.
• You will need 2-conductor speaker cable that clearly identies each
conductor in the cable. If burying your cable in the ground is required, use
cable rated for direct burial or run cable through PVC pipe. Always use
moisture resistant cable. If you are using an SI model in single speaker stereo
mode, it will require a 4-conductor cable as it needs to carry both left and
right stereo channels.
• After calculating the length of cable needed for each speaker, use the furthest
length cable to determine the gauge (thickness) of speaker wire to use:
Wire Gauge Maximum Distance
16 60 ft (18 m)
14 100 ft (30 m)
12 160 ft (50 m)
• When running wires inside walls or outdoors, you should install your wires
while conforming to your local building requirements and codes. If you are
unsure of these codes, consult a professional audio/video installer, building
contractor or local building and inspection agency that has jurisdiction.
• If the one-speaker stereo mode is used for this installation, remember that
each speaker uses two separate cables to get their signals. Plan the number
and length of cables, accordingly.
DS00333-0-All_Rock_Spkrs_Manual_RevC.indd 9 11/16/11 11:12 AM
Bekijk gratis de handleiding van Niles RS6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Niles |
| Model | RS6 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 3152 MB |
