Handleiding
Je bekijkt pagina 12 van 61
EN
www.newair.com 12
ASSEMBLY & INSTALLATION
UNPACKING YOUR FREEZER
• Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
• Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
ADJUSTING YOUR FREEZER
• Your freezer is designed for freestanding installation only. It should not be
recessed or built-in.
• Place the freezer on a floor strong enough to support it fully loaded.
• When moving the freezer, never tilt it more than a 45 degree angle. This
could damage the compressor and the sealed system.
• If the freezer is tilted let it stand in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.
PROPER AIR CIRCULATION
• To assure your freezer works at the maximum efficiency it was designed
for, you should Install it in a location where there is proper air circulation,
plumbing and electrical connections.
• The following are recommended clearances around the freezer:
• Sides 4" (102mm)
• Back 4" (102mm)
• Top Do not block
Bekijk gratis de handleiding van NewAir NFT050GN00, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | NewAir |
| Model | NFT050GN00 |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 6443 MB |
