NEO Tools 11-997 handleiding
Handleiding
Je bekijkt pagina 5 van 17
Paweł Kowalski
TOPEX GROUP Qualitätsbeauftragter
Warschau, 2023-06-14
EN
Instructions for use and proper use of the Jump Starter emergency
device.
1. Flashlight
2. Air pressure display
3. Energy quantity control
4. Boot device socket
5. Power button
6. DC15V / 0.4A charger input
7. USB 5V - 2A socket
8. USB 5V - 1A socket
9. Compressor connection
10. Compressor switch
LED lighting
Press the power button for 3 seconds to turn on the flashlight
- another short press - quick beating
- another short press - slow blinking
- another short press - turning off the flashlight and then the light
Avoid shining directly in your eyes.
Air pumping function
1. Screw one end of the tubing onto the compressor connector on the
device
2. Screw the other end onto the tire valve
3. Set the target pressure on the display
pressure (+/- buttons)
4. Turn on the compressor start switch
5. The device will turn off when the set pressure is reached
ATTENTION !
1. After working for 7 minutes, a break of 10 minutes is required.
2. The tubing ends may be hot after pumping
Emergency vehicle start:
1. Make sure that the number of indicator lights is not less than 3.
2. Connect the red clamp to the positive pole of the vehicle's battery
and the black clamp to the negative pole.
3. Plug the connecting cable into the socket on the device.
4. Start the vehicle
5. After the vehicle has started, disconnect the cable from the jump
starter and disconnect the red and black battery terminals from the
vehicle battery terminals within 30 seconds.
6. Leave the vehicle engine running.
Charging devices from USB sockets:
1. Connect the USB cable to the 5V-1A or 2A USB output.
2. Connect the USB cable to the socket on the device being charged
3. Press switch 5
Device control and charging
Energy quantity controls
Press the switch 5 to check the charging status of the device
LEDs
1
2
3
4
Charge level
25%
50%
75%
100%
In the event of a low battery level, connect the included power adapter
to the charging socket 6
The indicator lights will flash while charging.
The number of fixed light indicators indicates the state of charge.
Questions and Answers:
Question: How to turn off this device?
A: This device will automatically shut down when there is no load for 20
seconds.
Question: How long will it take for the device to fully charge my cell
phone?
A: Ex: Battery capacity 3500mAh: 1A (3-4 hours) 2A (2-3 hours)
Question: How many times can a fully charged device start the vehicle?
A: About 20 times For a motor with a starting current of 400A or less）
Question: How long will it take to fully charge the device?
A: 3-6 months, however, we suggest you charge it every 1-2 months
Contents of the package:
LP
Name
Quantity
1
Boot device
1
2
USB cable
1
3
Charger
1
4
Pressure hose
1
5
Compressor adapters
3
6
Car emergency start cable
1
7
User manual
1
Warnings
Do not connect the terminals of the boot device together.
Bekijk gratis de handleiding van NEO Tools 11-997, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | NEO Tools |
| Model | 11-997 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5111 MB |
