Nelson TWIG handleiding
Handleiding
Je bekijkt pagina 16 van 70
t
16 17
Optional power sources.
Every TD200 controller can be powered by either 110 V AC or alternatively a 12V DC battery having
a solar charger. If electricity is available then it is the preferred source of power.
Caution: Do not connect a 12VDC battery if the TD200 is plugged into electricity! Use only one
power source at a time! If using the 12VDC battery then it must be the only power supply that is
connected. The Demo Kit battery pack is to be used temporarily because the capacity of a set of AA
batteries will last about only a day. If electricity is available then it is the best source of power.
2.2 TWIG FIELD APPLICATIONS:
The TD200 is the foundation of the TWIG network:
The Nelson Wireless TWIG Control System basically consists of a TD200 Controller capable of con-
trolling up to 100 TWIGs in a programmed sequence. The TWIGs are located in the eld on solenoid
operated valves. The TD200 and the TWIGs that it controls are in a local area network. Each TWIG is
uniquely addressed with an identity that was assigned at the factory. The TWIGs automatically self
register to the designated TD200. A repeater can be installed in the network to facilitate the commu-
nications. And a Contact-TWIG can be added to the network to turn devices such as pump switch-
es on and off.
Bekijk gratis de handleiding van Nelson TWIG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nelson |
| Model | TWIG |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 23106 MB |