Necchi K417D handleiding
Handleiding
Je bekijkt pagina 16 van 60
10
Inserting the bobbin
n
Attention
Turn the power switch to off ("O").
When inserting or removing the bobbin,
the needle must be fully raised.
Remove the sewing table, then open the
hinged cover.
1
Hinged cover
1
3
2
1
4
Pull the bobbin case by the hinged latch.
Remove the bobbin of the bobbin case.
1
Hinged latch
Hold the bobbin case with one hand. Insert
the bobbin so that the thread runs in a
clockwise direction (arrow).
Pull the thread from the slot under the tension
spring and through the opening. Leave a
10cm tail of thread.
1
Slot
2
Tension spring
3
Opening
4
10cm
Hold the bobbin case by the hinged latch.
Make sure the bobbin case nger ts into
the notch at the top of the race as shown in.
Close the hinged cover.
1
Hinged latch
2
Bobbin case nger
3
Notch
Note
If the bobbin case is not properly placed
back into the machine, it will fall out form
the shuttle immediately after starting to
sew.
1
3
2
1
Bekijk gratis de handleiding van Necchi K417D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Necchi |
| Model | K417D |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 7138 MB |