Narwal Freo Z10 handleiding
Handleiding
Je bekijkt pagina 9 van 122
08
Boot seings
Push the robot into the base station with side brushes
facing outward. The base station will beep once to indicate
that charging is successful and the robot will turn itself
on and prompt a voice message.
Add clean water
• Unsnap the clean water tank and fill it with clean water.
• Close the clean water tank cap and put the clean
water tank back into the base station.
Place the detergent
• Remove the base station front cover, face the cap of
the detergent to the base station (DO NOT remove the
cap; make sure that the sealing sticker is removed), and
horizontally push it into the detergent bin.
• When the detergent is in place, put the base station
front cover back.
Place the base station
• Plug in the power cord in the back of the base station.
• Put the base station extension ramp on the floor and
push it into the boom of the base station until it clicks
into place.
• Leave an open space of at least 0.45 meter long in
front of the base station for the robot to enter and leave
the base station.
Tips: DO NOT put the base station close to a heat source.
Sealing sticker of
the detergent
MAX water level mark
Base Station Disinfection Dust Bag Installation
·Remove the base station front cover.
·Insert the dust bag into the slot in the marked direction
until it hits the boom.
·Put back the base station front cover.
Remove the foam and install the cleaning tray
·Remove the two foam pieces that secure the robot inside
the base station.
·Insert the cleaning tray into the base station and secure
it.
①
②
Bekijk gratis de handleiding van Narwal Freo Z10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Narwal |
| Model | Freo Z10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11436 MB |
