Handleiding
Je bekijkt pagina 4 van 7
2017 Page 4 of 4
1. Inspect and tighten all bearing collar and wheel set scr
ews after the first 50 to 100 hours of operation and periodically thereafter.
2. Follow motor manufacturer's instructions for motor lubrication. Remove any excess lubrication.
3. Check the drives.
a. Tighten set screws on pulleys, wheel and bearing locking collars.
b. Check belt tension and alignment.
c. Replace cracked or worn belts.
4. Blower bearings are permanently lubricated and require no further lubrication.
5. Inspect V-belts for wear and proper tension. If it is necessary to replace one belt on a multiple belt drive, replace all the belts with
a matched set. Do not use belt dressing.
1. Complete the electrical connections, energize the unit momentarily and ensure proper wheel rotation. (see Figure 5).
2. Apply full power.
3. With all ducts attached, the access doors in place and the air system in full operation, measure the motor current and ensure that it is
less than the rated full load motor amperage as indicated on the motor nameplate.
OPERATION
WARNING
ENSURE POWER SUPPLY IS DISCONNECTED & LOCKED OUT PRIOR TO MAKING ELECTRICAL CONNECTIONS.
MAINTENANCE
6. Clean the blower wheel periodically. Material build up on the blades
can cause wheel imbalance which may result in wheel or bearing
failure.
7. To reinstall replacement ball bearings press the locking collar
against the inner ring of the bearing and turn in the direction of the
shaft rotation until engaged.
Insert a drift pin into the pin hole and tap lightly to set. Tighten set
screw on locking collar firmly (see Figure 7 ).
8. Should further service to the blower be necessary, please contact
customer service.
BELT DRIVE SUPPLY FANS
ELECTRICAL
WARNING
ENSURE POWER SUPPLY IS DISCONNECTED & LOCKED OUT PRIOR TO MAKING ELECTRICAL CONNECTIONS.
WARNING
A GROUND WIRE MUST BE CONNECTED FROM THE MOTOR HOUSING TO A SUITABLE ELECTRICAL GROUND.
Before connecting the motor to the electrical supply, check the electrical characteristics and wiring instructions as indicated on the
motor nameplate or inside the conduit box cover to ensure proper voltage and phase. Complete electrical connections as indicated.
FIGURE 7
BEARING REPLACEMENT
Bekijk gratis de handleiding van NAKS SF7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | NAKS |
| Model | SF7 |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 1261 MB |
