Nabo FK 2755 handleiding
Handleiding
Je bekijkt pagina 20 van 24
19
• DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for
cleaning the appliance inner and outer surfaces. DO NOT use for cleaning cloths or
sponges that have coarse surfaces intended for scrubbing.
CHANGING THE OPENING DIRECTION OF THE DOORS
See fig. 6, page 2
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator
horizontally!
Before you start, please note the following:
∙ Always ensure that the correct number of washers is used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take the utmost care that they are
properly aligned during reassembly.
Warning: Always disconnect the unit from the mains before any maintenance or repair
work is carried out.
1. Open the refrigerator door. Remove the four covers C from the housing and inside of
the door.
2. Replace the covers and their extensions, turned through 180°, on the opposite side.
3. U nscrew the hinge bolt on the inside of the door in the area C/6.
4. Caution: Support the door.
5. Take off the refrigerator door. Take out the fi xing screws and remove the upper
bracket 6. Note the small plastic plate underneath the bracket.
6. Turn the bracket 6 including the small plastic plate through 180° and replace it on the
other side of the refrigerator, using the two screw holes adjacent to each other.
7. Remove the lower panel 1. Unscrew the hinge bolt 2, together with the washers, from
the bracket 7, and fi t it into the corresponding opening on the opposite side of the
bracket 7.
8. Place the refrigerator door onto the hinge bolt 2 on holding bracket 7.
9. Caution: Support the door.
10. Re-insert the hinge bolt of the bracket 6 into the refrigerator door.
11. Fit the four covers C over the bracket and the openings.Take out the cover 10 from
the lower panel 1 and replace it on the opposite side. Replace the panel 1 on the
appliance.
12. Remove the screw covering caps a and the sealing plugs b.
13. Take out the screws holding the door handle. Fit the handle on the opposite side, using
the fi xing screws to secure it. Push the sealing plugs (provided) into the now empty
openings in the door and replace the covering caps on the screw heads.
14. Remove the cover 10 from the lower cover 1 and insert it into the guides on the other
side of the lower cover (symmetrical to the previous position). Insert the left and right
legs of the lower cover 1 into the holes (see figure) and slide until the cover locks in
place.
Wait for about 30 minutes before it is connected to the mains. If the unit has been
tilted to more than 30°, wait for about 4 hours before re-connecting it to the
mains.
Bekijk gratis de handleiding van Nabo FK 2755, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nabo |
| Model | FK 2755 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2485 MB |