Nabo FK 2755 handleiding
Handleiding
Je bekijkt pagina 17 van 24
16
The appliance should be transported in the vertical position; do not tilt any
more than 30°. The manufacturer will not be responsible for any damage of the
appliance that results from non-compliance with the instructions for transportation.
INSTALLATION AND OPERATING CONDITIONS
Position:
• This appliance can be installed in a dry, well ventilated indoor where the ambient
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
The rear wall of the refrigerator, in particular, the condenser and other
elements of the cooling system must not contact other elements, which may
damage them, (e.g. central heating pipes and the water supply pipes).
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an
appropriate insulation board.
• Do not cover the ventilation holes at the top of the appliances– it must be a good air
circulation around the appliance. There should be a gap of at least 10 cm between the
top of the appliance body and any furniture that may be above it. If this requirement is
not followed, the appliance consumes more electrical energy and its compressor may
overheat (see fig. 4, page 2).
• If the appliance is placed in a corner, a gap must be left between the appliance body
and the wall (see fig. 5, page 2).
• The appliance must stand on a level surface and must not touch the wall. If necessary,
regulate the height of the appliance by adjusting the levelling feet: by turning them
clockwise – the front of the appliance rises, by turning them counter clockwise – it
comes down. If the appliance is tilted slightly backward – the doors will close by
themselves.
Preparing for operation:
• It is recommended to prepare the appliance for operation with a helper.
• Remove package. Remove the separate polystyrene part (transport protection) between
the rear of the device and condenser – metal grid (if available). Lift the appliance away
from foamed polystyrene base. When placing, moving, lifting the appliance, do
not hold the door handles, do not pull the condenser at the rear part of the
refrigerator and do not touch the compressor unit.
• When positioning the appliance in chosen location, it will move more easily into position
if you lift the front a little and incline it backward, allowing it to roll on its casters.
• Remove all red-coloured parts from the shelves (see fig. 2, page 1). Tear away the
adhesive tapes.
Bekijk gratis de handleiding van Nabo FK 2755, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nabo |
| Model | FK 2755 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2485 MB |