MuxLab 500439 handleiding
Handleiding
Je bekijkt pagina 2 van 2
© MuxLab Inc. 2017
Note: Power-on the Audio Extractor only after all connections are made.
4. Power-on the audio source and receiver. Verify the state of the connection based
on the LED status, see below.
When an HDMI signal is detected on the input, the HDMI In LED will be ON.
When an HDMI signal is detected on the output, the HDMI Out LED will be ON.
When a valid audio signal is processed, the Audio LED will be ON.
5. The following diagrams show the final configuration.
Troubleshooting
The following table describes some of the symptoms, probable causes and possible solutions
in regard to the installation of the HDMI Audio Extractor with Dolby & DTS Downmixer:
Symptom
LEDs
Probable
Cause
Possible
Solutions
Power
HDMI
In
HDMI
Out
Audio
No Video
OFF
OFF
OFF
OFF
No power
• Check power connections
No Video
ON
OFF
OFF
OFF
Source
• Check the source equipment.
No Video
ON
ON
OFF
OFF
Display
• Check the display equipment.
No Sound
ON
ON
ON
OFF
Connection
problem, or audio
source invalid or
not supported.
• Check RCA cable connection.
• Check the audio configuration of
the source.
Choppy
sound
ON
ON
ON
ON
Poor connection.
• Check RCA cable connection.
If you still cannot diagnose the problem, please call MuxLab Customer Technical Support at
877-689-5228 (toll-free in North America) or (+1) 514-905-0588 (International).
Bekijk gratis de handleiding van MuxLab 500439, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MuxLab |
| Model | 500439 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 592 MB |
