MSW -PLO-720 handleiding
Handleiding
Je bekijkt pagina 27 van 370
EN
DISPLAY, CONTROL PANEL AND SETTINGS
The main screen allows to set the main settings of the cutter like the cutting speed, cutting force and cut a test
pattern or check the amount of force that is currently set. Main screen options:
“Reset”
Resets the operation of the machine and set the
carriage arm to its right most position.
“Option”
Enter the offline-/pause-mode.
“Setup”
Enter the setup mode.
“Move”
Cuts a small test shape for testing the current force
and speed settings. Used to determine the proper
cutting speed and force settings needed for different
materials without wasting a bigger piece of them.
“Origin”
Used to test z-axis functionality (by dropping the
blade down if the carriage is functioning properly) or
to set a new origin
point when the machine is in
offline-mode.
↓ / ↑
Adjusts the cutting speed. A cutting speed of 300
mm/s is a (reasonable) default speed that can be used
for most cuts. When working with smaller and more
detailed images, a
slower speed may be required.
When working with larger and less detailed images, a
higher speed can be set for shortening the operation
time.
← / →
Adjusts the cutting force. A cutting force of 100g is a
good general starting place to work from when trying
to determine the force needed for a specific material.
All cuttable materials will tear in the amount of force
needed so proper testing should always be made to
determine the right amount of used force.
A proper amount of force is when
the blade fully
penetrates the material to be cut while not cutting
through the backing material.
Bekijk gratis de handleiding van MSW -PLO-720, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -PLO-720 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 118246 MB |
