MSW -PLO-375 handleiding
Handleiding
Je bekijkt pagina 36 van 370
EN
Paper deviation
occurred during cutting
Because the tension of paper press is inconsistent, rotate the two yellow brass nuts
on each paper press to the same height, then the pressure is balanced, as shown
below:
Rotate them to the same height.
The effect of small
graphics cutting is not
ideal.
When the cutting height is 3-5 mm letters, the software compensation value is set
to 0.45 and the speed is adjusted to 400 mm/s. When the cutting height is more
than 5 mm letters, the software compensation value is set to 0.3 and the speed is
adjusted to 600 mm/s or more:
Often repeated cutting,
cutting before
automatic paper and
other problems.
Cancel the automatic paper feeding function after cutting in the software, as
shown below:
Bekijk gratis de handleiding van MSW -PLO-375, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -PLO-375 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 118246 MB |
