MSW -ISU-TECH handleiding
Handleiding
Je bekijkt pagina 18 van 136
EN
3.4. Device use
3.4.1. Miter cutting
Miter cutting can be done in two ways: by adjusting the spool carrier on the overarm or with the
adjustable angle gauge.
Adjusting the spool carrier: loosen the screws 1 and 2 (Figure 3) and select the required angle by sliding
the spool carrier. Tighten the screw 1 again and tension the wire as usual.
Note: Adjusting the spool carrier will lengthen the heated part of the wire and thus increase the electrical
resistance. The temperature must be adjusted accordingly.
Figure 3
Working with the stop: Select the required miter on the angle stop and secure the adjustment with the
screw 1 (Figure 4). Move the extension 2 so that you can pass the cutting wire without difficulty. Press the
workpiece against the stop and guide the stop along the slot.
Figure 4
Bekijk gratis de handleiding van MSW -ISU-TECH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -ISU-TECH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25293 MB |
