MSW -ISU-STYRO 250 S4 handleiding
Handleiding
Je bekijkt pagina 29 van 200
EN
• Improper installation will result in the blade not being heated.
3.3. Device use
a) Set the temperature dial to the desired temperature - temperature control
dial has 16-click settings that correspond to the graduated ridges on the
surface. The smaller the ridge the lower the heating power setting.
b) Position the blade on the workpiece.
c) Turn on the heating trigger and warm up the tool a few seconds before
starting to cut (making a test cut on waste pieces is recommended).
d) Maintain consistency of temperature and speed. Too much mist/vapor may
be caused by low speed or excessive temperature. This will result in
irregular/uneven cut paths. You can solve this problem by lowering the blade
temperature or loosening the trigger.
e) Let go of the heating trigger before the last 3-5 cm of the cut is completed.
f) Proper temperature and cutting speed not only improve productivity, but
also extend tool life.
g) Cutting time should not exceed 15 seconds.
3.4. Cleaning and maintenance
Bekijk gratis de handleiding van MSW -ISU-STYRO 250 S4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -ISU-STYRO 250 S4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37883 MB |
