MSW -ISU-GIL ALU1 handleiding
Handleiding
Je bekijkt pagina 11 van 120
EN
OPERATION (Styrofoam cutter)
Switching On and Off
1. For startup it is only necessary to plug in the XLR-connector (1) of the transformer into the corresponding
socket on the bow and connect the power plug to the power socket.
2. Press the On/Off switch (2) and keep it depressed. The cutting wire is fully functional within seconds
3. Pull bow in direction of the material – material will be cut.
4. NOTE: fire risk! Release the On/Off switch after every cut has been implemented; the cutting wire cools
down within a few seconds.
Replacing the hot wire
Before any work on the machine itself, pull the mains plug and read all the instructions. Non-observance of the
instructions below can cause electric shock, fire and or serious personal injuries.
1. Carefully remove any remaining old hot wire.
2. Hook the new hot wire to one of the springs and then under tension to the opposite
spring. Be careful not to bend or damage the new hot wire during installation.
Bekijk gratis de handleiding van MSW -ISU-GIL ALU1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -ISU-GIL ALU1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37843 MB |
