MSW -CCSE-3500.420 handleiding
Handleiding
Je bekijkt pagina 30 van 352
EN
A- Plastic knob
PRACTICAL APPLICATION
1. The power supply voltage must match the voltage indicated on the tech plate.
2. Before operation, inspect the cutting blade. It must be installed correctly and rotate freely. Conduct a
no-load test for at least 30 seconds. Do not use damaged, deformed, or vibrating blades—damaged
blades may break and cause injury.
3. Waste dust from processing materials that contain lead-based pigments, minerals, or metals can be
hazardous to health. Ensure proper ventilation in the workplace. Wearing a P2-grade filter mask is
recommended.
REPLACEMENT OF CARBON BRUSH
1. Loosen the screws on the brush holder cover.
2. Remove the brush holder cover.
3. Open the coil spring.
4. Use pointed nose pliers to remove the carbon brush buckle and take out the carbon brush.
5. Install the original carbon brush and insert the buckle into the brush holder.
6. Cover the brush holder cover and screw in the screws to secure it.
NOTICE!
Check the size of the carbon brush after prolonged operation. If it is less than 7 mm, replace it promptly.
Failure to do so may result in damage to the motor.
Switch Operation
1. Power on: Press the anti-self-locking button, then press the switch button.
2. Shut down: Release the switch button.
Bekijk gratis de handleiding van MSW -CCSE-3500.420, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -CCSE-3500.420 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 73591 MB |
