Mr. Heater Electric Buddy MHBEW150FATRW handleiding

Niet gecategoriseerd

Mr. Heater

36 pagina's

PDF beschikbaar

Handleiding

Installation Instructions and Owner’s Manual

Wall Mounted Forced Air Electric Heater

TROUBLESHOOTING

OBSERVED SYMPTOM POSSIBLE CAUSE REMEDY

Heater will not operate.

Power is not on or power cord not

plugged into outlet.

Plug heater in to appropriate electrical outlet. Also,

check if electricity to the outlet is working. See SAFETY

FEATURES section for additional information.

The heater keeps

blowing air when heater

is turned OFF.

The heater is functioning as it

should. This is the cool down phase.

The heater will run for 3 minutes to

cool down the internal components.

This increases the lifespan of the

infrared elements.

N/A

The heater is not

blowing warm air.

The heater is functioning as it

should. The ambient temperature

(displayed) is higher than the

thermostat setting.

N/A

There is something blocking the air

flow.

Move the object out of the way of the heater.

The fan clicks on and

runs for under a minute

and then turns off.

The fan is turning on to pull air

across the thermostat. This creates

air flow within your room. The

heater is trying to determine if the

ambient temperature in the room

has changed.

N/A

The heater smells like

burning plastic.

When the heat function is used for

the first time, a slight odor may be

present. This is normal and should

not occur again unless the heater is

not used for an extended period of

time.

If the smell persists for more than a couple of hours, call

Technical Service at 800-251-0001.

Cord is getting very hot,

especially at the plug.

The connection from the wall

wiring to the outlet may be faulty

and causing the outlet and plug to

overheat.

Make sure there are not too many appliances plugged

into outlets on a single circuit. If problem still persists,

consult a qualified electrician to diagnose and repair.

Heater airflow is

diminished

Air inlet on heater blocked. Observe minimum installation clearances on page 4 of

manual.

Heater doesn’t seem

to reach the set

temperature, it just

keeps running.

If the room is drafty or poorly

insulated, the thermostat sensor may

be taking an inaccurate reading.

Make sure to keep doors closed so that the heater can

heat the room.

Heater installed near exterior wall or

below a window.

Move heater to interior wall or away from window.

Heater may be too small for the

room.

Attempt to heat with a larger heater.

Bekijk gratis de handleiding van Mr. Heater Electric Buddy MHBEW150FATRW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.