Handleiding
Je bekijkt pagina 38 van 134
38
EN
USING THE DEVICE
1. Connect the infrared radiator to the power supply and press the power button
(1). After starting, the device will emit an audible signal and the ON/OFF buttons
(2) and the operating time selection button (3) will be highlighted on the display
(4).
2. Press the ON/OFF button (2). The display (4) will show “P0”, which means that
the lamps are off. Pressing this button repeatedly changes the heating power
level, which is shown on the display and indicated by an audible signal. Three
adjustment levels are available:
► P1 – low heating level (650 W)
► P2 – moderate heating level (1300 W)
► P3 – high heating level (2000 W)
3. To change the angle of the radiator and thus the angle of the heat flow, simply tilt
the device housing (5) while holding the tube with your other hand to prevent
the radiator from tipping over.
4. The operating time selection button (3) can be used to set the time after which
the device will automatically switch off. The selection of the appropriate time is
shown on the display and signalled by an audible signal. Available time can be
selected from 1 to 24 hours.
5. After finishing work, turn off the device using the power button (1) and discon-
nect it from the power supply.
CAUTION! The infrared radiator is equipped with an automatic shut-off system in case of
tilting or tipping over.
6. All functions can also be controlled using the remote control (10), which has
buttons that perform the same functions as those on the device.
CLEANING AND MAINTENANCE
CAUTION! Unplug the device from the mains and wait until it has cooled completely before
cleaning.
CAUTION! Do not immerse the device in water or other liquids.
1. Solvents, insecticides and other strong substances must not be used for cleaning. This could
cause damage to the unit’s housing or electrical failure.
2. The device housing should be cleaned with adamp cloth and detergent, then wiped with adry
cloth.
3. The lamp guard should be cleaned periodically with abrush to remove accumulated dust.
4. Although the radiator is approved for outdoor use (on balconies and terraces), for your own
safety, DO NOT immerse it in water. Wait until the device is completely dry before use.
5. The remote control is powered by aCR 2025 battery. To access the batteries, open the con
-
tainer located at the bottom of the remote control. When replacing the battery, make sure it is
correctly installed, paying attention to the polarity.
Bekijk gratis de handleiding van MPM MUG-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MPM |
| Model | MUG-25 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 12230 MB |
