Handleiding
Je bekijkt pagina 5 van 22
5
EN
APPLIANCE DESCRIPTION
1. Blender housing
2. ON/OFF knob – two-speed opera-
on and PULSE funcon
3. Jug mounng socket
4. Rubber seal
5. Pitcher base ring with stainless steel
knife
6. 1500 ml glass blender jug
7. Jug handle
8. Jug cover
9. Jug cover cap
10. Non-slip feet
ASSEMBLY OF THE BLENDER JUG
1. Make sure that a rubber seal seal is properly installed inside the jug base ring (5).
CAUTION! The blades are sharp. Handle with care. Handle the knife only by its plasc base.
2. Turn the blender jug (6) so that the opening for screwing the base on is pointed upwards.
3. Place the jug base ring (5) over the hole with the knife facing the inside of the jug and screw it in
clockwise, taking care to t the threads correctly.
In case of deinstallaon of the jug base ring (5), act in a reverse order.
USING CUP BLENDER
Note: The appliance is equipped with a safety system to prevent accidental start-up. If the jug is
incorrectly ed, the blender will not start.
NOTE: The appliance is designed for blending food at a temperature of no more than 50 °C.
1. Place the blender housing (1) on a dry, hard and even surface.
2. Aer making sure that all blender jug parts are assembled correctly, put the blender jug (6) on the
blender enclosure (1) and gently turn it clockwise. Ensure that the latches t correctly.
3. Cut the products into smaller parts to make mixing easier. Put ingredients into the jug only when
the motor is stopped.
NOTE! Do not ll the jug above the mark of 1500ml (6).
4. Place the lid with the hole plug.
5. Plug the appliance into the power supply socket.
6. Turn it on with the knob (2), choosing one of two operang modes.
7. During mixing always hold the lid. If you need to add ingredients when the cup blender is running,
remove the hole plug from the lid (9) and feed the ingredients through the hole, and then replace
the plug (9).
8. When mixing is complete stop the appliance by turning the knob (2) to the <<0>> posion and
unplug the power supply plug from the socket.
9. Certain products, e.g. ice cubes, should be crushed by repeatedly using the PULSE funcon.The
PULSE funcon works by turning and holding the switch knob to the le as far as it will go. To
improve crushing of the ice cubes, pour a small amount of water.
ATTENTION! Before pouring out the content of the jug wait unl the knife stops rotang!
NOTE! Do not start the motor for more than 1 minutes, because it may become over heated.
Aer these 1 minutes stop the appliance and wait unl it cools down but not less than 3 minutes.
INSTRUCTIONS FOR USE
1. Boiled vegetables and fruit should cool down before pung them into the blender jug.
2. Blender is not designed for the following:
Bekijk gratis de handleiding van MPM MBL-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MPM |
| Model | MBL-37 |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 2810 MB |
