Handleiding
Je bekijkt pagina 28 van 48
28
EN
Tilt the device slightly
backwards and support it
to keep it stable.
Remove the door hinge
bolts and the hinge pin
bracket.
Open the door slightly and
pull it out downwards.
Unscrew the upper pin and
screw it into place on the
opposite side.
Put the door on top pin and
close it.
Screw the hinge pin bracket
rmly into place on the
opposite side using screws
If the door opening direction is considered as a nuisance, it can be changed.
For this purpose, holes are made on the opposite side of the device housing and covered with
plugs.
Unscrew the lower hinge with the foot and the washer and remove the door.
Using a screwdriver (counter-clockwise), unscrew the pin serving as the upper hinge and
screw it on the opposite side.
In place of the corner of the door with the opening, insert the corner without the opening
and vice versa.
Put the door on the bolts acting as the upper hinge.
Place the pin of the lower hinge with the foot (together with the washer) in the corner with
the hole and screw the lower hinge.
Finally check the adherence of the magnetic seals (the seal must not be twisted and must
adhere precisely along its entire length). All places, where the gasket does not adhere to the
housing of the device, should be heated from an appropriate distance (e.g. with a hair dryer),
and then gently stretch it to the desired length of the gasket.
Bekijk gratis de handleiding van MPM -100-ZS-11, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MPM |
| Model | -100-ZS-11 |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 4364 MB |
