Moulinex Optimo GM4110 handleiding
Handleiding
Je bekijkt pagina 28 van 29
26
IS THERE ANY PROBLEM?
Problems Possible causes Solutions
Water runs through the holes in
the sole plate.
The boiler is too full.
The thermostat is not working :
the temperature is too low.
You are using the steam control
button before the iron is hot
enough.
Water has condensed in the
pipes because you are using
steam for the first time or you
have not used it for some time.
Do not fill the boiler right up to
the top.
Contact an Approved Service
Centre.
Check the thermostat and
steam flow* settings.
Press the steam control button
away from your ironing board
until the iron produces steam.
White steaks come through the
holes in the soleplate.
Your boiler has a build-up of
scale.
Rinse the boiler every 10 uses
(see § rinsing the boiler). If your
water is hard, increase the
frequency.
Brown streaks come through the
holes in the soleplate and stain
the linen.
You are using chemical
descaling agents or additives in
the water for ironing.
Never add this type of product in
the boiler (see § what water to
use).
The soleplate is dirty or brown
and may stain the linen.
You are ironing at too high a
temperature.
Your linen is not rinsed sufficiently
or you have ironed a new
garment before washing it.
You are using starch.
See our recommendations
regarding temperature control
setting.temperatura.
Ensure linen is rinsed thoroughly
to remove any soap deposits or
chemicals on new garments
which have been sucked up by
the iron.
Always spray starch on the
reverse side of the fabric to be
ironed.
There is no steam. The boiler is empty.
The boiler is not yet ready.
Fill the boiler.
After starting the appliance, wait
for 8 mins or until the steam
ready indicato light* comes on.
Steam escapes from the boiler
cap.
Cap screwed on incorrectly.
The seal on the cap is damaged.
The appliance is faulty.
Screw the cap back on.
Contact an Approved Service
Centre.
Stop using the generator and
contact an Approved Service
Centre.
Steam or water escape under
the appliance.
The appliance is faulty. Stop using the generator and
contact an Approved Service
Centre.
If you have any product problems or queries please contact our Customer Relations Team first
for expert help and advice:
HELPLINE: 0845 602 1454 - UK (01) 461 0390 - Ireland or consult our website -
www.moulinex.co.uk
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
* depending on model
Pressing Optimo 00010789ok 13/07/06 15:28 Page 26
Bekijk gratis de handleiding van Moulinex Optimo GM4110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Moulinex |
| Model | Optimo GM4110 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3181 MB |
