Motorola Minitor 7 handleiding
Handleiding
Je bekijkt pagina 13 van 38
Item Description
9 External Speaker Jack
10 Accessory Connector
11 Antenna Connector
12 DC Connector
1.1
Standard Features
External Antenna
The external antenna input jack (BNC connector) is located on the rear of the Amplifier Charger housing.
An external antenna must be attached to the Amplifier Charger for maximal reception.
Audio Amplifier
The Amplifier Charger contains a 2.5 watt audio amplifier and speaker. When a MINITOR 7 device is
placed in the Amplifier Charger, the audio is routed to the Amplifier Charger speaker rather than to the
device speaker.
External Speaker Jack
An external speaker jack, located on the rear of the Amplifier Charger housing, allows the user to attach
an external speaker. When an external speaker is connected, audio will be routed to that speaker rather
than to the Amplifier Charger internal speaker. The minimum speaker impedance is 4 ohms.
Relay
The Amplifier Charger includes a relay that is energized whenever an alert is received, and a 6-pin DIN
accessory connector is located on the rear of the unit. The 6-pin mating plug for these models may be
wired to provide the following functions:
● Remote Speaker Audio (Pins 1 and 6)
An external 4-ohm speaker may be connected to the Amplifier Charger via pin 1 (audio) and pin 6
(ground return) of the plug, to provide both remote speaker audio and internal speaker audio at the
same time.
● Relay Dry Contact Closure (Pins 2 and 3)
When the accessory relay is energized, its contacts close and present a short across pins 2 and 3 of
the connector. The relay contacts are rated for 10 watts maximum at 28 VDC/AC
RMS
. Within the limits
of the 10-watt rating the closed contacts can handle up to 750 mA continuously and switch up to 400
mA of current. Relay contact rating: 750 mA maximum @ 28 VDC.
● Relay Closure Timing Control (Pins 4 and 5)
Accessory connector, pins 4 and 5, are used to select the time duration of the relay contact closure. If
these two pins are not used (open circuit), the relay remains energized for approximately 10 seconds
after an alert is received or until the reset button is pressed, whichever comes first. If pins 4 and 5
are shorted, the relay remains energized until the reset button on the front of the Amplifier Charger is
pressed. Pressing the reset button causes the contacts to open to turn off the ALERT indicator.
MN010322A01-AA
Chapter 1: Charger Overview
13
Bekijk gratis de handleiding van Motorola Minitor 7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Motorola |
| Model | Minitor 7 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3382 MB |
