Mooer Ocean Machine II handleiding
Handleiding
Je bekijkt pagina 21 van 29
18
Operation
Menu knob
Rotate Menu to adjust the Looper playback volume level. This is independent from the master mix.
REC / PLAY / DUB / STOP / CLEAR (REV footswitch)
x With an empty track: Tap once ĨŽƌZĞĐŽƌĚƚĂƉĂŐĂŝŶĨŽƌWůĂLJƚĂƉĂŐĂŝŶĨŽƌƵď
x Double-tap for Stop (when Looper is in Play mode)
x Hold for Clear All (when Looper is in Stop Mode)
LED indication:
R Off: nothing recorded (e.g. after Clear All)
R Blinking slowly: the Looper is recording or over dubbing
R Continuously lit: the Looper is playing back
R Blinking quickly: the Looper is in Stop-Mode
HALF SPEED (A footswitch)
x Half-Speed on / off
When half-speed is active, the footswitch LED is lit and the status is indicated in the screen.
REVERSE (B footswitch)
x Reverse loop on / off
(this effect is available after the first loop was recorded)
When reverse loop is active, the footswitch LED is lit and the status is indicated in the screen.
Notes:
x When the Looper is recording and the first layer of recording is full, the Looper will automatically
switch to Dub (and record the next layer).
x While the Looper is operating, you can go back and forth between the Looper and your current
operation mode by pressing the Looper button. You cannot change the operating mode
(i.e. use A + B footswitches to switch between Play and Patch) while in Looper mode.
x If the Looper is playing and the pedal is in Play Mode, the loop will continue playing, even if all
effects are turned off. In Patch Mode, however, the playback will be muted, if the pedal is
switched to global bypass (REV footswitch).
Looper positioning
The Looper can be placed at different positions in the effects chain. (See section Positioning effects in
the signal chain)
x In front of the chain, the Looper will record (and then play) the dry signal directly from the input.
This can be used to record a dry signal of the instrument and apply Delay / Reverb effects after
the Loop was recorded. This "clean" recording can then be moved further back in the chain so
different or no effects (end of chain) will be applied to the loop as compared to the live input from
the instrument.
x In the middle of the chain, the Looper will record any effects that have been applied to the signal
before the Looper position. These effects will remain recorded in the loop and always be audible
even if the recorded loop is moved in the signal chain and even if all effects on the pedal are
Bekijk gratis de handleiding van Mooer Ocean Machine II, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mooer |
| Model | Ocean Machine II |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6628 MB |
