Monitor Audio Bronze 7G handleiding
Handleiding
Je bekijkt pagina 10 van 13
16 17
Using your speakers
Running-in your loudspeakers
Run your loudspeakers in by playing normal music at low-mid listening levels for approximately
50-70 hours play time. You may ind the sound will continue to improve even after the 70 hour
mark.
This can be done naturally over time: like a ine wine the performance will improve with age.
Alternatively if you wish to run the loudspeakers continuously on loop you can decrease the
audible volume/presence by placing the loudspeakers face-to-face so that the drivers/tweeters
are directly aligned and as close as possible. Then connect the ampliier to your loudspeakers so
that one is as normal (in phase): positive to positive and negative to negative (red to red and black
to black), and the other loudspeaker out of phase: positive to negative and negative to positive
inputs on the loudspeaker.
Port bungs (Bronze 50 7G, Bronze 300 7G & Bronze On Wall 7G only)
If the loudspeaker is to be installed in a small room, typically 9 sqM (80 sqFT), or a room known
to reproduce accentuated bass response, it may be desirable to it a port bung in the aected
speaker. However, experimentation is recommended with positioning of the loudspeaker in the
room prior to itting. To optimise performance from the loudspeaker it is important to ensure the
loudspeaker is not positioned too close to a wall (except the Gold On Wall 7G) or near the corners
of a room.
If the positioning of the loudspeaker is predetermined by room aesthetics or layout, you ind you
have accentuated bass or in the case speakers are to be sited in close proximity (less than the
minimum suggested distances of page 6) to a rear wall (such as on a bookshelf, positioned in a
cabinet or on a stand close to a wall), we recommend itting the supplied port bungs to the ports.
With speakers that have 2 ports, such as the Bronze 300 7G, only one port bung should still be
used per speaker.
This will reduce the bass ‘boom’ sometimes termed as overhang, and assist the loudspeakers
to reproduce their best performance under these environmental conditions. ‘Boom’ is
generally caused when bass energy from the loudspeaker ‘excites’ room modes and causes an
accentuation at a particular frequency, or number of frequencies.
When itting port bungs the overall bass extension will not be reduced, however bass energy/
output around the port tuning frequency will be reduced. This has the eect
of reducing bass ‘boom’ while increasing bass clarity and apparent agility.
In all circumstances experimentation is highly recommended.
Bekijk gratis de handleiding van Monitor Audio Bronze 7G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Monitor Audio |
| Model | Bronze 7G |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 970 MB |
